How to Install Get Mounted Paint Protective Circle (PPF) for Mini Mount Magnets

June 1, 2026

Protect Your Vehicle's Paint with the Get Mounted PPF Circle

The Get Mounted Paint Protective Circle (PPF) is a simple but essential accessory for anyone using the Starlink Mini Magnetic Mount on a vehicle. The magnetic mount is incredibly strong — and without protection, repeated attachment and removal can cause micro-scratches or swirl marks on your paintwork over time. The PPF circle sits between the magnet and your vehicle's surface, acting as a sacrificial layer to keep your paint looking factory-fresh.

What's Included

Get Mounted PPF Circle (pre-cut to fit the Starlink Mini Magnetic Mount)

What You'll Need

Clean microfibre cloth
Isopropyl alcohol (IPA) or panel wipe
Your vehicle surface (roof, bonnet, or any steel panel)

Step 1 – Clean the Surface

Before applying the PPF circle, thoroughly clean the area where your magnetic mount will sit:

Wipe the surface with isopropyl alcohol or panel wipe using a clean microfibre cloth.
Remove all dust, wax, grease, and contaminants.
Allow the surface to dry completely before proceeding.

Tip: Avoid applying in direct sunlight or on a hot surface — find a shaded spot for best adhesion.

Step 2 – Peel the PPF Circle

Carefully peel the PPF circle from its backing.
Handle by the edges to avoid fingerprints on the adhesive side.

Step 3 – Apply the PPF Circle

Position the PPF circle on the cleaned surface where your magnet will sit.
Press firmly from the centre outward to remove any air bubbles.
Run your fingernail or a soft card around the edges to ensure full adhesion.

Tip: Take your time with placement — once applied, repositioning may reduce adhesion.

Step 4 – Allow to Bond

For best results, allow the PPF circle to bond to the surface for at least 30 minutes before attaching the magnetic mount. This ensures maximum adhesion and protection.

Step 5 – Attach Your Magnetic Mount

Once the PPF circle is firmly in place, attach your Starlink Mini Magnetic Mount as normal. The PPF layer will protect your paint from the magnet while maintaining a strong, secure hold.

Maintenance Tips

Inspect the PPF circle periodically for lifting edges — press back down if needed.
Clean around the PPF circle when washing your vehicle.
Replace the PPF circle if it becomes damaged or loses adhesion.
Available as a replacement from Get Mounted.